Canoga-perkins 9161 Network Interface Device Bedienungsanleitung PDF herunterladen (Seite 42)

5.4.2 New Installation

On new installations, make sure that all steps in Chapter 2 are complete, then follow these steps:

1. Check that the STA LED is green.

2. Check that the fiber type is single mode.

3. Make these checks:

• All fiber cabling is of the same type; do not mix multimode and single mode cables.

• The fiber optic cable is within the specifications and loss budget of the optic interface

module.

• The line length between the 9161 and the remote link does not exceed the allowable loss

budget or overdrive limit.

• All host modules in the link are turned on.

• All fiber cables are connected Tx to Rx and Rx to Tx.

5.4.3 Problems With Fiber Optics

If a port information screen shows that a link is down, inspect and clean the cables and connectors,

then replace any damaged fiber. Retest modules after cleaning.

9161 Network Interface Device

5-4

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Keine Kommentare

Canoga-perkins 9161 Network Interface Device Bedienungsanleitung Seite 42